Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI
7
INSTALLATION (CONTINUED)
STEP 4 – MOUNTING A MICROFLASHER TO A/V COMPONENTS
Make sure all of your remote controls have batteries and that they are able to operate the A/V
components. Locate a place for the remote control that is within arm’s length of the A/V compo-
nents, yet cannot directly control them. Place the Microsensor no closer than two feet in front of the
remote control (Figure 6).
Hold the MicroFlasher four inches in front of the remote Microsensor window on the A/V compo-
nent’s front panel. Press buttons on the remote control while watching the front panel of the A/V
component. When the component responds repeatedly to the commands, peel off the protective
backing on the MicroFlasher and place the MicroFlasher in that location.
If the A/V component’s remote is not clearly marked,
slowly move the MicroFlasher over the window of the
A/V component while pushing buttons on the remote
control until you get a response (Figure 7).
Repeat this procedure for each A/V component you
wish to control.
When the A/V component responds repeatedly, peel off
the protective backing on the MicroFlasher and place
the MicroFlasher in that location.