Nokia 110T Satellite TV System User Manual


 
Connecting the Mediamaster
GB 8
Common connections
There are many different types of TV/VCR and other equipment that
you can connect to the Mediamaster.
In this section, you will see some of the most common ways to
connect your equipment.
If you have problems with your connections and need help, contact
your retailer or Nokia Support.
Connecting to the TV with SCART
Remove the aerial lead from your TV and connect this to the TV
AERIAL input socket on the Mediamaster.
Connect a SCART cable between the main SCART socket on the TV
and the TV SCART socket on the Mediamaster.
Connect an RF cable from the TV/VCR output on the Mediamaster
to the RF input socket on the TV.
Switch on your TV, then plug in and switch on your Mediamaster.
You may need to select the AV (SCART) channel on your TV to
watch digital TV. In some cases, your TV will automatically
select this channel when the Mediamaster is switched on.
NOTE: The RF lead will need to be connected in order to watch
analogue channels (the old 1, 2, 3, 4, 5)
It is always advisable to consult the user guide that came
with your TV.
Connecting to the TV without SCART
Remove the aerial lead from your TV and connect this to the TV
aerial input socket on the Mediamaster.
Connect an RF cable from the TV/VCR output on the Mediamaster
to the RF input socket on the TV.
Switch on your TV, plug in and switch on your Mediamaster.
Select a programme number on the TV that is not currently used
for other TV channels.
Follow the instructions in your TV manual to tune the TV to pick
up the First-time installation menu.
Follow the instructions in your TV manual to store this channel.
When the First-time installation menu is visible, press the select
button on the Mediamaster's remote control to start the
installation procedure.
If the picture quality is bad, you can later change the pre-defined
UHF channel 43 to any other number between 21 and 69. You will
also have to tune your TV to the same (= the new) channel number.
For more information, see RF modulator output channel setting
on page 16.
RF
SCART
RF