Filter
Top Products
4 WWW.ONEFORALL.COM
Direct code set up
Example: To set up the ZAPPER for your Television follow the instructions below.
1 Make sure your TV is switched on (not on standby).
2 Find your Television code in the Set-Up Code section (page 52-66). Codes are listed by
brand name. The most popular codes are listed first.
3 Open the flap to enable access to the MAGIC key.
4 Press the TV key.
5 Press and hold the MAGIC key until the LED blinks twice (The LED
underneath the POWER key will blink once then twice).
6 Enter your 5-digit code according to the chart below.
The LED underneath the POWER key will blink twice.
7 Now, aim the ZAPPER at your Television and press POWER. If your
Television switches OFF, your ZAPPER should be ready to operate your device.
8 If the functions do not work properly, repeat steps 4 –7 using another code listed under
your brand.
For example: To enter a Sony TV code 33121, you would press CHANNEL +,
CHANNEL +, VOLUME +, VOLUME -, VOLUME +.
To set up your DVD player or Satellite Receiver please press the corresponding
device key during step 4.
Important notes:
- Some codes are quite similar. If your television does not respond or is not functioning
properly with one of the codes, follow steps 1-5 with each code listed for your brand.
- If none of the codes listed for your brand operate your television, follow the Search
Method described in the next section. The Search Method can be used even if your
brand is not listed at all.
TV
DVD
SAT
RIGHT = 1
LEFT = 2
DOWN = 4
OK (MUTE) = 5
UP = 3
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
SET UP
706113_URC-6230-31_E_10t:Zapper_3 06-12-2007 14:51 Pagina 4