Filter
Top Products
Installing the Batteries
Your ONE FOR ALL needs 2 new “AA/LR6” alkaline batteries.
1 Remove the battery cover from the back of your ONE FOR ALL by
p
ressing down on the tab.
2 Match the batteries to the + and - marks inside the battery case,
then insert the batteries.
3 Press the battery cover back into place.
See picture of ONE FOR ALL TV remote on page 3
1 MAGIC Key
The MAGIC key is used to set up your ONE FOR ALL 4.
2 POWER
The POWER key operates the same function it did on your original
remote control. The red light (LED - Light Emitting Diode)
underneath the POWER key will light up every time a key
is pressed.
3 MENU Key
The MENU key controls the same function as it did on your original
remote.
4 DIRECTIONAL KEYS
If available on your original remote, these keys will allow you to
navigate through the menu mode of your device.
5 OK
The OK key will confirm your choice in menu operation.
6 Programme (Channel) +/- Keys
These keys operate in the same way as the keys on your original
remote.
7 MUTE Key
The Mute key operates the same function it did on your orginal
remote control.
8 Volume +/- Keys
These keys operate in the same way as the keys on your original
remote.
The Keypad
Important notes:
- In order to avoid having to reprogram your ONE FOR ALL after
you remove the batteries, you will need to insert new batteries
w
ithin 5 minutes. Also it is best that you do not use rechargable
batteries.
-
On the inside of the battery compartment door you will find a
label on which to write your Set-Up code after your ONE FOR ALL
i
s set up for your device. Please write down your code for easy,
future reference.
WWW.ONEFORALL.COM 4
704983_URC-7210_E_10T:BIG Easy_1_E_10T 01-06-2007 15:57 Pagina 4