Filter
Top Products
USING LEARNING
Programming A Learning Key (continued)
4. Press a device key once (e.g., TV) to assign a desired
mode for learning.
5. Select an open learning key (e.g.,L1) and press it
once.You will see the display change to [LEARNING]
and the LED (red light) will turn on for 5 seconds.
6. Place your original remote control (e.g., TV remote
control) head-to-head (about 2" apart) from the
URC-8910 remote control.
7. On your original remote control, press and hold the
key (i.e., feature) to be learned until until you see
[SUCCESS] appear on the URC-8910 remote control.
The display will return to device mode you selected
for learning (e.g., TV).
If the key was not learned, you will see an [ERROR]
message instead.
Repeat steps 5 through 7 as needed to achieve
[SUCCESS].
8. To learn functions onto other learning keys (e.g.,L2
~ L4), repeat steps 4 through 7 for each key.
9. Press EXIT to exit the programming mode.You will
see an [EXIT SETUP] message as the remote control
returns to normal operation.
10. To test a learned feature, aim the URC-8910 remote
control at the desired device and press its device key
once (e.g., TV,where the learning mode was
assigned). Then press the learning key (e.g., L1)
2"
17
Producer 2002 IR Mnl 4/4/02 10:01 AM Page 30