One for All URC-8910 Universal Remote User Manual


 
5. Enter a macro sequence of up to 15 keys. For our
example, press the following keys once in this order:
TV - 7-1
NOTE: If you have access to over 100 channels, add a 0
before the channel numbers (e.g., 0-7-1). If the original
remote control required pressing an
Enter key to change the
channel, also press the Enter key after the channel number
(e.g., 0-7-1-ENTER).
NOTE: An [ERROR] message, followed by [MAX = 15] alerts
you that the macro sequence must be 15 keys or less.
After pressing the first key (in the macro sequence),
you will see the display change to [SEL TO END].This
message acts as a reminder to use SELECT to end the
sequence (see next step).
6. To end the macro sequence, press and hold SELECT
until you see [SUCCESS] appear in the display,
followed by [EXIT SETUP]. The URC-8910 remote
control will automatically exit the programming
mode and return to normal operation.
Now when you press M1, you will instantly see cable channel 71 on
your TV set.
Programming A Master Power Key With Instant
Channel Selection
A macro key can be programmed to turn on and off your devices as
well.For example, let’s set up a sequence that will turn on the TV
and tune it to channel 3,and then turn on the cable converter and
tune it to a premium channel (e.g., 11).
NOTE: This example assumes all equipment is turned off and that the TV is
connected through the cable converter with TV tuning set to channel 3.
1. Perform steps 1 through 4 of the previous section,
Programming A Favorite Channel on page 34.
However, this time in step 4,substitute another open
macro key (e.g.,M2).
2. Enter a macro sequence of up to 15 keys. For our
example, press the following keys once in this order:
CBL - POWER - TV - POWER- 0-3 - CBL- 1-1
NOTE: If you have access to over 100 channels, add an 0
before each set of channel numbers (e.g., 0-0 -3 and 0-1-1).
If the original remote control required pressing an
Enter key
to change the channel, also press the Enter key after each
channel number (e.g., 0-0-3-ENTER and 0-1-1-ENTER).
continued on next page...
22
Producer 2002 IR Mnl 4/4/02 10:01 AM Page 35