Filter
Top Products
SETUP
SETUP
FAV CH
9 - 9- 6
9
- 9 - 6
SETUP
SETUP
Using the Favorite Channel Key
Your
One For All
®
Easy 4
is equipped with a
favorite channel key (FAV CH). You can set up the
FAV CH key with a list of up to 10 of your favorite
channels for either your TV, VCR, Cable Box,
Satellite or DSS. Please note, the FAV CH key can
only be set up for one device key (TV,VCR/LD or
CBL/SAT) at a time. You cannot set up a favorite
channel list for another device key until you have
cl
eared the FAV CH key of your original list.
1 Press the device key (TV, VCR/LD, or CBL/
SAT) for the home entertainment
component that will contain your
favorite channel list.
2 Press and hold SETUP until
One For All
®
Easy 4’s
red light blinks twice. Release
SETUPand press 9-9-6.
3 Enter the channel number of the first
channel you would like to add to your
favorite channel list. Then press SETUP.
• If you are entering a single digi
t
channel number, you must press
0 first.
• If you are entering a channel that
is three digits long, such as 103,
you do not have to press SETUP
after you have entered the
channel number.
• If your original remote control
required you to use an ENTER key to
change channels, press ENTER
instead of SETUP after entering your
channel number. For example, if you
want to add TV channel “4” to your
favorite channel list, you would: Pre
ss
TV, then press and hold SETUP until
the
One For All
®
Easy 4’s
red light
blinks twice, then release SETUP and
press 9-9-6. Press 0-4,followed by
ENTER. Then, add your second
channel, followed by ENTER, and
continue adding your favorite
channels until you have added the
10 channels you desire in your
favorite channel list.
4 Continue adding your favorite
channels, up to 10 channels. Once you
have finished, press and hold SETUP until
th
e
One For All
®
Easy 4’s
red light blinks
twice.
5 To scan through your favorite channel
list, press FAV CH. Your
One For All
®
Easy
4
will automatically scan through your
favorite channel list, stopping at each
channel for three seconds.
6 To stop at one of your favorite channels,
press any key on the
One For All
®
Easy
4
.
To clear an entire favorite channel list from the
FAV CH key:
1 Press and hold SETUP until the
One For
All
®
Easy 4’s
red light blinks twice, then
release SETUP.
2 Press 9-9-6, then press and hold SETUP
until the
One For All
®
Easy 4’s
red light
blinks twice.
TV
VCR/LD
CBL/SAT
SETUP
9 - 9 - 6
9
- 9 - 6
One For All
®
PRODUCTS
Limited Warranty
One For All(“OFA”) warrants, to the original purchaser only, that
this product will be free from defects in materials and workmanship,
under normal use, for ninety (90) days from the date of original
purchase.
This warranty does not cover damage or failures caused by
products or services not supplied by OFA, or which result from
accident, misuse, abuse, neglect, mishandling, misapplication,
faulty installation, set-up adjustment, improper maintenance,
alteration, maladjustment of consumer controls, modifications,
commercial use, or that is attributable to acts of God.
There are no express warranties except as listed above. OFA SHALL
NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF
ANY BREACH OF WARRANTY. ALL EXPRESS AND IMPL
IED
WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE
WARRANTY PERIOD SET FORTH ABOVE. Some states do not allow
the exclusion or limitation of incidental or consequential damages,
or limitations on how long an implied warranty lasts, so the above
exclusions or limitations may not apply to you. This warranty gives
you specific legal rights and you may also
have other rights which
vary from state to state.
To obtain warranty service for a defective product during the
warranty period, please return the product, preferably in the original
carton, along with your purchase receipt, to the store of original
purchase. A note detailing the complaint would be helpful. The
store, at its option, will replace or repair this product if found to be
defective.
One For All
One
For All
®
is a trademark of Universal Electronics Inc.
Copyright 1996 by Universal Electronics Inc. No part of this
publication may be reproduced, transmitted, transcribed,
stored in any retrieval system, or translated to any language, in
any form or by any means, electronic, mechanical, magnetic,
optical, manual, or otherwise, without the prior written
permission of Universal Electronics Inc.
This One For All
®
product is designed for compatibility in North
America excluding Mexico.
URC-4063 - One For All
®
Big Easy Select Easy 4.
M4022
5/98
Replace the batteries with four (4)
new AAA alkaline batteries.
Make sure you are aiming your
One For All
®
Easy 4
at your home
entertainment component and
that you are within 15 feet of the
component you are trying to
operate before using your
remote.
Try all the codes listed for your
home entertainment component
in the "Set-Up Codes" section.
Many set-up codes may allow for
partial functionality, however, only
one set-up code will operate your
home entertainment component
properly. Make sure that all of the
components you are setting up
are able to be operated with an
infrared remote control.
Use the VCR set-up codes for your
brand. Some combo units may
require both a TV code to control
volume and a VCR code for ful
l
operation.
As a safety feature on the
One
For All
®
Easy 4
, you must press the
REC key twice.
Press and hold SETUP until the
One
For All
®
Easy 4's
red light blinks
twice. Release SETUP and enter
9-9-3 followed by VOL +.
Due to RCA design (1983-1987),
only the original remote control
will operate these functions.
However, using the FAV CH key will
allow you to run through a list of
up to 10 of your favorite channels.
If your original remote control
required a ENTER keystroke when
changing channels, press the
ENTER key on the
One For All
®
Easy 4
after you enter the
channel number.
Press and hold SETUP until the
One For All
®
Easy 4's r
ed light
blinks twice. Release SETUP and
enter 9-6-9.
Troubleshooting
Problem Solution
Red light not blinking
when you press a key?
The red light blinks
when you press a key
but you receive no
response from your
home entertainment
component ?
The
One For All
®
Easy
4
does not operate
your home
entertainment
component or is not
performing
commands properly?
Problems program-
ming a TV/VCR
combo?
VCR not recording?
No volume when in
the Cable mode or
when operating a
second TV or TV/VCR
combination?
Channel +/- and
RECALL not working for
your RCA TV?
Problems changing
channels?
Keypad scrambled?
World Wide Web: http://www.oneforall.com
This product has been discontinued and is no
longer supported.