Filter
Top Products
69
DISPLAY
ENTER
Prog. Memory
Move
Select
Off 1 2 3
Check
■ Adjusting the picture quality settings
– To create your own setting (2)
1 Use the cursor button (3) to select [Start] then press
ENTER.
Memory
DNR
Sharpness
Detail
Chroma Delay
Gamma
min max
min max
off max
green red
Off
On Off
123
Interlace Video Memory Select
Interlace Video Setup
(North American model when set to [Interlace] setting in
the Setup screen Video 1 menu, and other models)
Fine Focus
Switch [On] to reveal greater detail (higher resolution) in the
picture
Contrast
Adjusts the contrast of the elements in the picture.
Sharpness
Adjust the sharpness of the high-frequency (detailed) elements in
the picture. (This setting is only effective when [Fine Focus] is
[On].)
Chroma Level
Adjusts how saturated colours appear.
Hue
Adjusts the overall red/green color balance.
Memory (Interlace Memory)
Program the current settings.
5 Use the cursor buttons (2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
6 Repeat steps 4 and 5 to make adjustments to other
settings.
If you would like to save the settings in the player’s memory, be
sure to select either [1], [2], or [3] in the [Prog. Memory] or
[Memory (Interlace Memory)] setting to establish which memory
location to save the new settings in. Please note that if you select
a location where settings have already been saved, the old
settings will be replaced by the new ones.
2 Use the cursor button (∞) to select [Video Setup] and press
ENTER.
3 Press DISPLAY.
4 Use the cursor buttons (5/∞) to select the setting and use
the cursor buttons (2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
5 To memorize the setting, select Memory 1, 2, 3, then press
ENTER.
The previous setting will be erased.
7 When you are finished making adjustments, press ENTER
to establish the new settings.