Filter
Top Products
55
Pre-programming remote controller
(USA and Canadian models only)
Learning a pre-programming code
You can make RC-449DV remote controller to operate a TV
from other brand than Onkyo by storing the pre-programming
code of the brand in the RC-449DV.
Set the DVD/TV switch to TV.
Find the 2-digit number for the brand
name of the component that you want
to operate in the table on page 56.
Turn on the TV that you want to
operate.
While holding down the STANDBY
button on the RC-449DV that you
want to program, press the ENTER
button, and then release both
buttons.
Within 30 seconds, enter the 2-digit
code number.
Press some operation buttons for
the component that you want to
operate to check if the system
operates properly.
If the system operates properly, the code is
correct. If the component does not operate
properly, return to step 3.
Notes
• With some brand’s components, some buttons may not work
correctly.
• If more than one code is given in the table, try the code one by
one until you reach the code for your component (i.e. if the first
code does not work, then try the next).
• The code can be retained by changing the batteries within 1
minute. If the code is lost, store the pre-programming code again.
1
2
3
4
5
6
Controlling a TV
Set the DVD/TV switch to TV.
Press the ON button to turn on the
device.
Press the desired operation button.
CH+ : Changes the TV channel
upward.
CH– : Changes the TV channel
downward.
TV VOL+ : Increases the TV volume.
TV VOL– : Decrease the TV volume.
TV/VCR :Switches the TV/VCR inputs.
TVDVD
ENTER
STANDBY
23
456
789
1
0
+
10
1
TVDVD
2
ON
3
LAST M COND.
M DIMMER DISPLAY
STANDBY
ON
ANGLE AUDIO
SUBTITLE
MENU
TOP MENU
SETUP
RETURN
STOPPAUSE
FUNCTION M
OPEN
/
CLOSE
DOWN UPFR FF
CLEAR
PROGRAM
RANDOM REPEAT A
-
B
STEP/
SLOW
SEARCH
REMOTE CONTROLLER
RC
-
449
DV
PLAY
23
456
789
1
0
+
10
+
-
ENTER
TV
ON
/
STANDBY
VOL
+
VOL
-
TV/
VCR
CH
+
CH
-
TVDVD
ENTER
ON
STANDBY
VOL +/–
CH +/–
DVD/TV
Number buttons