8
STANDBY/ON
STANDBY
POWER
OFF
ON
PHONES LEVEL
MIN MAX
PHONES
DVD
PLAYER
DV-S
525
OPEN
/CLOSE
STOP
PLAY
DIMMER
PAUSE
VIDEO
S VIDEO
Y
C
B
C
R
OPTICAL
COAXIAL
REMOTE
CONTROL
ANALOG
OUTPUT
R
L
D
I
G
I
TAL
OUTPUT
COMPONENT
VIDEO OUTPUT
VIDEO OUTPUT
■ Front panel
Front panel/rear panel/DVD display
Identification of Controls
DVD display
Disc tray
PAUSE button
STOP button
PLAY button
OPEN/CLOSE button
Up/Down buttons
STANDBY indicator
DIMMER button
PHONES LEVEL knob
PHONES jack
Connections for remote control ( z )
When connecting ONKYO products, it is necessary to attach the z cable to be able to use the remote controller of the main component to
control the entire system.
1.To use this DVD player with an amplifier (or receiver), cassette tape deck and tuner with the z symbol, insert the remote control
cable plugs into the REMOTE CONTROL jacks.
2.As the exact connection sequence of the z cable is unimportant, you can connect from the amplifier (or receiver) to either the
tuner, the cassette tape deck or to the compact disc player.
3.If using an z equipped ONKYO amplifier (or receiver), to operate correctly, the remote controller must face towards the remote
control sensor of the amplifier (or receiver).
• The upper and lower z remote control jacks have the same function.
• Remote control operation is not possible when only the remote control cable is connected — the audio connection cables must also be
connected.
• An z remote control cable equipped with a 1/8" (3.5mm) diameter miniature two-conductor phone plug is included with this unit
and with every tuner, compact disc player or cassette tape deck with the z symbol.
STANDBY/ON button
POWER switch
Power plug
Power cord
ANALOG AUDIO OUT (L/R) jacks , ,
COMPONENT VIDEO OUT jacks
Y•CB•CR
DIGITAL COAXIAL AUDIO OUT jack ,
VIDEO OUT jack , ,
S VIDEO OUT jack
z REMOTE CONTROL jacks
DIGITAL OPTICAL AUDIO OUT terminal ,
■ Rear panel
Notes:
See the page in for details.
Remote contol
sensor