14
Connecting to an Amplifier
(To Enjoy the Sound Advantage of the DVD Player)
Before connecting
• Refer to the instruction manual of the amplifier.
• When you connect the DVD Player to the amplifier, be sure to turn off
the power and unplug both units from the mains before making any
connections. Otherwise, the speakers may be damaged.
• Connect the plugs securely.
Notes
• The remote controller supplied with Onkyo amplifier can be used
to operate the DVD player.
• The function of the upper and lower z connectors are the same.
Connect to either one.
• Connecting z cable only does not make the system operational.
You must also connect the audio cables as well.
• For remote control operation, the audio connection cables must
also be connected.
■ Making a digital connection with the
amplifier
If your amplifier has a digital input jack, be sure to connect
it to either DIGITAL OUTPUT OPTICAL or COAXIAL jack
on the DVD player.
Notes
• DO NOT connect to the AC-3RF input (e.g. of a Dolby Digital
receiver) which is reserved only for video disc players.
■ Making the analog connection with the
amplifier
If your amplifier has no digital audio input, you can make
the analog connection. If the amplifier has a Dolby Pro
Logic decoder, you can reproduce the Dolby Pro Logic
surround sound.
An amplifier with a Dolby
Digital/DTS/MPEG1/MPEG2
decoder or 2 channel digital
stereo
Although you can reproduce the DVD Player’s sound from the TV speakers with the connections on the opposite page,
connecting with an amplifier provides you high quality dynamic sounds.
To reproduce Dolby Digital surround, MPEG1 audio, MPEG2 audio, and DTS surround sound, you need to connect to an
amplifier with a Dolby Digital, MPEG1 audio, MPEG2 audio, and DTS decoder respectively.
An amplifier with no
digital connection
: Signal flow
Optical fiber connection cable
To Digital optical jack
Incomplete
Insert completely
L
MONO
R
VIDEO OUTPUT
Y
P
B
P
R
COMPONENT
OPTICAL
COAXIAL
AC
INLET
REMOTE
CONTROL
ANALOG
OUTPUT
DIGITAL
OUTPUT
VIDEO
S VIDEO
MODEL NO.
DV
-
SP500
DVD
PLAYER
Stereo audio
connection cable
To audio input
Coaxial connection cable
To Digital coaxial jack
z cable
To z jack
z cable
To z jack
DO NOT connect the
mains lead at this time.
Be sure to set the digital output setting after
connection using the Setup Navigator explained in
“Setting Up the Player” starting on page 16 or the
function setting menu explained in “Adjusting
Audio and Video Settings” starting on page 38.