Filter
Top Products
9
Preparing the Remote Controller
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller is
not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this will
vary depending on usage.
30˚
30˚
About 5 m
Remote control sensor
1 Open the battery compartment cover.
2 Insert the two R6 (size AA) batteries.
Be sure to match the + and – ends of the batteries
with the diagram inside the battery compartment.
3 Close the battery compartment cover.
Inserting the Batteries
Using the Remote Controller
Point the remote controller toward the remote control
sensor.
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of the
remote controller.
• Using another remote controller of the same type in the same room
or using the unit near equipment which uses infrared rays may
cause operational interference.
• Do not put any object such as a book on the remote controller. The
buttons of the remote controller may be pressed by mistake and
drain the batteries.
• Make sure the audio rack doors do not have colored glass. Placing
the unit behind such doors may prevent proper remote controller
operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.