Filter
Top Products
45
DISPLAY
ENTER
Interlace Memory
Move
Select
Off 1 2 3
Check
■ Adjusting the picture quality settings
– To create your own setting (2)
1 Use the cursor button (3) to select [Start] then press
ENTER.
Interlace Video Memory Select
Interlace Video Setup
5 Use the cursor buttons (2/3/5/∞) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
6 Repeat steps 4 and 5 to make adjustments to other
settings.
If you would like to save the settings in the player’s memory, be
sure to select either [1], [2], or [3] in the [Memory] setting to
establish which memory location to save the new settings in.
Please note that if you select a location where settings have
already been saved, the old settings will be replaced by the new
ones.
2 Use the cursor button (∞) to select [Interlace Video Setup]
and press ENTER.
3 Press DISPLAY.
4 Use the cursor buttons (5/∞) to select the setting and use
the cursor buttons (2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
5 To memorize the setting, select Memory 1, 2, 3, then press
ENTER.
The previous setting will be erased.
7 When you are finished making adjustments, press ENTER
to establish the new settings.
(Screen display during
interlace set up of component
output)
(Screen display during
interlace set up of component
output)
Interlace Memory
Fine Focus
Contrast
Sharpness
Chroma Level
Hue
On
Off
soft fine
min max
min max
green red
Off 1 2 3
(Screen display during
interlace set up of component
output)