Filter
Top Products
37
Using a Macro function
A series of remote controller button operations can be memorized
into the MACRO DIRECT button for one-touch control.
Note:
You can program only one series of button operations into the
MACRO DIRECT button.
1. Press and hold down any one of the eight MODE buttons
and press the MACRO DIRECT button. Then, release the
buttons.
When you press the MODE button, the SEND/LEARN indica-
tor lights up. When you press the MACRO DIRECT button, the
indicator turns off. When you release the buttons, the indicator
flashes briefly, then lights up again.
2. Follow Steps 2 in the “Programming Macro Mode” on page
36.
3. Press the MACRO DIRECT button to complete the proce-
dure.
The SEND/LEARN indicator flashes twice slowly.
4. Check to see if the button has been programmed correctly.
Point the RC-391M toward the TX-DS575 and press the
MACRO DIRECT button, and make sure that the device
responds as programmed.
Transmitting the codes in Macro mode takes a while. During
transmission, point the remote controller toward the device to
be controlled.
Note:
• You may program up to 16 button operations into the MACRO
DIRECT button. If you try to program the 17th step, it will be
ignored.
• If you do not press any button for more than 30 seconds during
the procedure, the SEND/LEARN indicator flashes three times
quickly, then the RC-391M exits Learning mode. Resume Step
1.
• If you make a mistake during programming, the SEND/LEARN
indicator flashes three times quickly, then the RC-391M exits
Learning mode. Resume Step 1.
• If you erase one of the operation buttons already programmed in
the MACRO MODE button, or if you program a different code
into such a button, the operation button will no longer work. In
this case, program the buttons again to avoid malfunction.
Macro Direct Learning function
1, 3
1
Tip:
The codes programmed into a MACRO button will be
transmitted with an interval of 0.5 seconds. However,
some devices may not be able to complete one opera-
tion in 0.5 seconds and may miss the next code. In this
case, press one operation button, press the correspond-
ing MODE button, then press another operation button
to extend the interval between the two operations up to
one second.