Filter
Top Products
65
Using remote controller
Controlling an Onkyo DVD player
The connector of the Onkyo DVD player must be connected to
the TX-SR700/700E/600/600E (see page 29).
1. Press the DVD MODE button.
The DVD MODE button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo DVD player.
Operation buttons:
ON: Turns DVD player on and off
STANDBY: Turns DVD player off (Some sets may not respond to
this button. In this case, use the ON button to put the DVD player in
the standby state.)
SETUP: Displays OSD Menu of the DVD player
: Moves cursor in the OSD Menu of the DVD player
ENTER: Enter button for the OSD Menu of the DVD player
RETURN: Return button for the OSD Menu of the DVD player
TOP MENU or MENU: Displays menu screens recorded on DVD
media
DISC
: Selects disc in DVD changer
AUDIO SEL: Selects audio or language track (if recorded on the
DVD)
ANGLE: Selects camera angle (if recorded on the DVD)
SUBTITLE: Selects subtitle language (if recorded on the DVD)
SEARCH: Searches for location on disc to start playback
RANDOM: Random playback
: Chapter/Track down
: Chapter/Track up
: Play
: Stop
: Fast reverse
: Fast forward
: Pause
OPEN/CLOSE : Opens/closes disc tray
0, 1 to 9, +10: Numeric keys
You may also use the following buttons:
VOL : Adjusts volume at TX-SR700/700E/600/600E
MUTING: Activates muting function at TX-SR700/700E/600/
600E
Note:
When operating an Onkyo DVD player directly with the remote
controller without connecting the
terminals, pre-programming is
necessary (see page 67).
DVD
operation
buttons
Numeric keys
VOL
MUTING
ON STANDBY
DVD MODE
SUBTITLE
TOP MENU
RETURN
AUDIO SEL
ANGLE
ENTER,
SEARCH
SETUP
MENU
DISC