Filter
Top Products
66
Controlling an Onkyo MD recorder
The conneÇóctor of the Onkyo MD recorder must be connected
to the TX-SR700/700E/600/600E (see page 29).
1. Press the MD MODE button.
The MD MODE button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo MD recorder.
Operation buttons:
ON: Turns on and off MD player (same as the STANDBY button on
the remote controller)
: Track down
: Track up
: Play
: Stop
: Skip backward
: Skip forward
REC: Record
: Pause
: Eject
1 to 9, 0, --/---: Numeric keys
ENTER: Enters settings
You may also use the following buttons:
VOL : Adjusts volume at TX-SR700/700E/600/600E
MUTING: Activates muting function at TX-SR700/700E/600/
600E
VCR and TV MODE buttons
No preset codes are programmed into the VCR and TV MODE
buttons. Therefore you can use these buttons to program the remote
controller signals of other devices.
There are two methods. One method is selecting the name of a
different brand from the table, entering the setting number listed, and
calling up the pre-programming code (see page 67). The other
method is sending the commands from the other brand’s remote
control directly into this remote controller (see page 70).
When in the VCR and TV mode, you may use the following buttons:
VOL
: Adjusts volume at TX-SR700/700E/600/600E
MUTING: Activates muting function at TX-SR700/700E/600/
600E
TV
: Turns on and off the television
(and switches to the TV mode)
VCR : Turns on and off the VCR
(and switches to the VCR mode)
MD
operation
buttons
Numeric keys
Using remote controller
MD MODE
VOL
MUTING
ON STANDBY
ENTER
VOL
MUTING
VCR MODETV MODE
TV
VCR