Filter
Top Products
SETUP MENU OPTIONS
30
Audio Setup Page
1. SPDIF Output: To set the bit stream type of the digital audio output. The options are:
• RAW – Passes the encoded multi-channel digital audio unaltered. Choose this setting if
your receiver/amplifier is capable of decoding Dolby Digital and DTS.
• PCM – Forces down-mixed 2-channel digital audio output. Choose this setting if your
receiver/amplifier only supports PCM audio.
2. LPCM Out: To set the maximum Linear PCM output frequency. The options are:
• 48K – Supported by most equipment.
• 96K – Better sound can result. Ensure that the receiver/amplifier can support it.
• 192K – Better sound can result. Ensure that the receiver/amplifier can support it.
3. PRO Logic II: To configure the Dolby Pro Logic II function. Dolby Pro Logic II technology can
expand 2-channel source audio into full 5-channel surround sound.
• Pro Logic II configuration is accessible only when down-mix is set to 5.1ch and SPDIF
output is set to Raw.
• Press the SELECT button to enter the Pro Logic II setup page.
• Press the LEFT ARROW button to exit the Pro Logic II setup page.
A. Pro Logic II: To turn on or off the Pro Logic II processing. The options are:
• On – Pro Logic II processing is always on
• Off – No Pro Logic II processing
• Auto – Pro Logic II processing is on only when Dolby Pro Logic II encoded content
is detected.
B. Mode: To set the processing mode of Pro Logic II. The options are:
• Music – Sound from all speakers arrive at the same time with no delay
• Movie – 10ms delay is added to the surround channels
• Pro Logic – Earlier version of Dolby Pro Logic processing
• Auto – Automatically selects processing mode based on content
C. Panorama: To turn on/off panorama mode. When turned on, front stereo audio is
extended to the surround channels for an enveloping effect.
D. Dimension: To increase or decrease the dimensional effect by adjusting the front to
rear balance. As the size number increases, the sound localization moves towards
forward from backward.