Optimus 63 (HI-FI) (16-633) VCR User Manual


 
14
VCR SETUP
SETTING THE VCR’S OUTPUT
CHANNEL SWITCH
If you connected the VCR’s
VHF/UHF OUT TO
TV
terminal to a TV or another VCR, set
3 CH. 4
on the back of the VCR to
3
or
4
, whichever is
not an active channel in your area.
When VCR appears, the VCR sends the signal
from the video source connected to its
IN FROM
ANT.
jack or
R-AUDIO-L IN 1/VIDEO IN 1
(or
AV2
for the Model 63) terminals to the TV on the
channel you selected.
Note:
Setting
3 CH. 4
has no effect on the TV
when the VCR is off or if you connected a TV
with separate audio/video input jacks to the
VCR’s
R-AUDIO-L/VIDEO IN
jacks.
REMOTE CONTROL
Installing Batteries
The remote control requires two AA batteries
(not supplied). For the longest operation and
best performance, we recommend alkaline bat-
teries (such as RadioShack Cat. No. 23-557).
Cautions:
Use only fresh batteries of the required
size and recommended type.
Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
1. Press the tab on the battery compartment
cover and lift off the cover in the direction
of the arrow.
2. Put fresh batteries in the compartment, as
indicated by the polarity symbols (+ and –)
marked inside.
3. Replace the cover.
Note:
When the remote control stops working
or operates poorly, replace both batteries.
Cautions:
Never leave dead or weak batteries in the
remote control. Batteries can leak chemi-
cals that can damage your remote control.
Dispose of dead batteries promptly and
properly; do not bury or burn them.
Using the Remote Control
To use the remote control, aim it at the front of
the VCR and press the desired function but-
tons.
Tab
+
16-551.fm Page 14 Tuesday, July 20, 1999 5:13 PM