Filter
Top Products
•
Shaded buttons are used for following operation.
The unit’s picture controls, brightness, contrast,
color, tint and sharpness, are preset to factory speci-
fications. Although they are usually the best, you
may need to make some further adjustments for a
more natural looking image.
1 Press [PICTURE] then press [
K
] or [
L
] to
select the desired control “BRIGHTNESS”,
“CONTRAST”, “COLOR”, “TINT” or “SHARP-
NESS”.
2 Press
[
s] or [B
]
to adjust to your desired
level within 5 seconds.
•
Even if there is a power failure of any kind, the
unit will retain its memory for this feature.
•
The picture control display will disappear automati-
cally after 10 seconds unless you press any buttons.
1 Press [SETUP] then press [
K
] or [
L
] to point
to “BACK LIGHT”.
2 Press [ENTER] then press [
s
] or [
B
] to
select to “BRIGHT”, “NORMAL” or “DARK”.
3 Press [SETUP].
The Sleep Timer function turns off the unit without
using [POWER] after a desired period of time.
1 Press [SLEEP].
2 Press [SLEEP] repeatedly until the desired
sleep time is displayed.
•
Each press increases the time by 10 minutes up
to 90 minutes.
•
After 5 seconds, the Sleep Timer setting will
disappear automatically.
•
If you select “SLEEP 0 MINUTE”, Sleep Timer
setting is canceled.
- 13 - EN- 13 - EN
PICTURE CONTROL
BRIGHTNESS
-+
PICTURE
SLEEP TIMER
SLEEP
REV
SLOW
PLAY
STOP
FWD
ENTER
PAUSE
DISC
MENU
RETURNTITLESETUP
A
-
B
REPEATSEARCH MODE
CLEAR
MODE
ANGLESUBTITLEAUDIO
DISPLAY
SKIP
VOL.
MUTEZOOM
SLEEP
789
0 +10
+100
SELECT
POWER PICTURE
EJECT
3
BACK LIGHT SETTING
BRIGHTNESS to decrease to increase
brightness brightness
CONTRAST to decrease to increase
contrast contrast
COLOR to pale to brilliant
TINT to purple to green
SHARPNESS to soft to clear
SETUP
- TV SET UP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
B BACK LIGHT [BRIGHT]
ENTER
SETUP
SLEEP 0 MINUTE
SLEEP
TV SECTION
TV OPERATION AND SETTINGS
NOTE