Filter
Top Products
- 19 - EN
1C29
TV OPERATION
DEGAUSSING
Magnetism from nearby appliances and speakers
might affect the color of the TV picture.
If this happens, move this TV/VCR/DVD away from
the appliance. If the color is still not correct, turn off
using the POWER button, then turn it on again 30
minutes or so later (27” model), or unplug the power
cord, then plug it in again 30 minutes or so later (19”
model).
TV/VCR
WATCHING A TV PROGRAM
1 Turn on the TV/DVD/VCR
Press the POWER button to turn on the
TV/DVD/VCR.
2 Select the channel number
Press the CHANNEL button K or L to select your
desired channel number or press the number on the
remote control.
Note for using the Number button on the remote
control:
¡When selecting cable channels which are higher
than 99, press +100 first, then, press the last two
digits. (Example: to select channel 125, first press
“+100” then press “2” and “5”).
¡You must precede single-digit channel numbers
with a zero (For example: 02, 03, 04 and so on).
Remember: If the TV/DVD/VCR is connected to a
cable box or satellite box, the TV/DVD/VCR must
be on CH3 or CH4, then the channel to be viewed
must be selected on the cable box or satellite box.
3 Adjust sound
Press the VOLUME button
XX
or
YY
to adjust the volume.
NOTES:
•
If you press the CHANNEL button o or p in the
DVD mode, you can change the TV channels.
Even if you turn off the TV/DVD/VCR in the
DVD mode, when you turn it on again, it will go
into the TV/VCR mode.
TV/VCR
Arrow button s Arrow button B
BRIGHT to decrease to increase
brightness brightness
CONTRAST to decrease to increase
contrast contrast
COLOR to pale to brilliant
TINT to purple to green
SHARPNESS to soft to clear
PICTURE CONTROL
The TV/DVD/VCR’s picture controls – BRIGHT,
CONTRAST, COLOR, TINT and SHARPNESS –
are preset to factory specifications. Although they are
usually the best, you may need to make some further
adjustments for a natural looking image.
NOTES:
•
Procedures must be followed within 5 seconds or
the Picture Control mode will be cancelled.
•
When setting the Picture Control, the Game mode
will be cancelled.
Make sure ...
•
TV/DVD/VCR power must be turned on.
1 Select “PICTURE CONTROL”
Press the PICTURE button on the remote control.
2 Select item you want to adjust
Press the Arrow button K or L until desired control
is displayed.
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
3 Adjust the picture control
Press the Arrow button B or s to adjust to your
desired level.
TV/VCR
•
If there is a power failure of any kind, the
TV/VCR/DVD will retain its memory for this fea-
ture.
VOLUME 20
C C C C C C C C C C C C
BRIGHT
–
PPPPPPPPPPPPPPCCPPPPPPPPPPPPPP
+
TD900UA(P01-35).QX33 03.8.29 4:50 PM Page 19