Sylvania LC200SL9 Flat Panel Television User Manual


 
[] Basic Connection
Thissectiondescribeshowto connecttheunit toanantenna,cablereceiverorsatellitebox.
Note:
Besureyourantenna or other device is connected properly before plugging in the power cord.
[Antenna Cable Connection]
When connecting the unit to an antenna or cable TV signal (without cable receiver/satellite box)
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VHF/UH_I_
antenna II rearofthisunit
t
RF coaxial cable
ca ble TV
signal
_Once connections are completed, turn on the unit and begin initial setup.
Channel scanning is necessary for the unit to memorize all available channels in your area.
(Refer to"Initial Setup"on page 11.)
Note:
Ifyou have any question about the DTV'santenna, visit www.antennaweb.org for further information.
Foryour safety and to avoid damage to device,please unplug the RFcoaxial cable from the antenna input jack before moving the unit.
Ifyou use an antenna to receiveanalog TV,it should also work for DTVreception. Outdoor or attic antennas will be more effective than set-
top versions.
Toeasilyswitch your reception source between antenna and cable, install an antenna selector.
Ifyou connect to the cable system directly, contact the CATVinstaller.
[Connection to Cable Receiver or Satellite Box]
Use an RCA component video cable to connect the component video input jack of the unit to the component video
output jack of the cable receiver / satellite box.
If you connect to the unit's component video input jack, connect RCA audio cable to the audio L/R jack of VIDE02.
e,g.) rear of this unit
satellite
dish
RFcoaxial
(green) (blue) (red)
AUDIO OUTq COMPONENT VIDEO OUT
f L R Fy Pb/Ob PriOr_
cable receiver / satellite box
RCA audio cable
You can also connect this unit to the cable receiver or satellite box other than the component video output jack
because they might have different output jacks.
Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear
QAM may differ depending on the cable/satellite provider. For more information, please contact your cable/satellite
provider.
EN