Open as PDF
Before you can use any of the special channel buttons (CH / , FAV.CH, PRE.CH), the antenna you wish to
use must be scanned for available channels.
Press the MENU ( ) button on your remote control.
buttons to select the
Channel menu and press the
( ) button.
buttons to select Auto
Program and press the
ENTER ( )
buttons to select an
antenna and press the
ENTER ( )
“Auto Channel in Progress.” will
be displayed while your available
channels are scanned. Upon
completion, your Set-Top Box will
store all the available scanned
• Your Set-Top Box MUST be connected to an antenna in order to receive
digital TV signals.
• Even if a speciﬁc channel is removed from the memory, you can always tune
to that channel directly by using the
NUMERIC buttons on your remote
• If you wish to stop scanning in the middle of the scanning process, press
the ENTER ( ) button to select the stop command, and then press the
ENTER ( ) button to select OK.
• If you have changed the connected antenna, use the
on your remote control to change the selected antenna after scanning
23 2006-10-12 ｿﾀﾈﾄ 1:13:40