Filter
Top Products
- 12 - EN
1C29
TO RECORD A SCRAMBLED/UNSCRAM-
BLED CHANNEL
1. Set the TV/VCR/DVD channel selector to the out-
put channel of the Cable Converter Box or Satellite
Box. (Ex. CH3)
2.Select the channel to record on your Cable
Converter Box or Satellite Box.
INSTALLING THE BATTERIES
1)Open the battery compartment cover by pressing
the cover on the remote unit in the direction of the
arrow.
2)Insert 2 “AA” penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the cover.
EXTERNAL INPUT MODE
When using an external input signal (another VCR,
video camera or video game), connect the player’s
audio/video output cables to the
AUDIO L/R IN/ VIDEO IN jacks
of your TV/VCR/DVD. Then press
the CHANNEL button K or L until
“AUX” appears on the screen.
AUX
Note to CATV system installer:
This reminder is provided to call the CATV sys-
tem installer’s attention to Article 820-40 of the
NEC that provides guidelines for proper ground-
ing and in particular, specifies that the cable
ground shall be connected to the grounding sys-
tem of the building as close to the point of cable
entry as practical.
CONNECTING TO EXTERNAL
INPUT JACKS
When you watch a program recorded on another
source (VCR, video camera or video game), use the
audio/video input jacks on the front of the
TV/VCR/DVD.
Connect the audio/video output jacks of another
source to the AUDIO L/R and VIDEO jacks of this
TV/VCR/DVD.
Then press the CHANNEL button K or L until
“AUX” appears on the screen.
NOTE:
•
When you connect a monaural VCR (another
source) to this TV/VCR/DVD, connect the Audio
output jack of the monaural VCR (another source)
to the AUDIO L jack of this TV/VCR/DVD. The
audio will output in both L and R channel equally.
VIDEO AUDIO RL
HEADPHONE
[Another source]
To the audio
output jacks
Audio/Video
cable
(not supplied)
etc.
To the video
output jack
[Front of the
TV/VCR/DVD]
[Fig. 5]
T1055UF_EN(p1-35).QX3 04.6.3 2:43 PM Page 12