Filter
Top Products
- 19 - EN
1C29
TV OPERATION
DEGAUSSING
This television has a degaussing circuit that will clear
up color errors on the TV screen that are caused by
any excess magnetism which happens to get too
close to the TV. This circuit is designed to operate
once when the set is first plugged in. If minor color
errors are seen in some locations on the screen,
please unplug the TV for approximately 15 minutes.
When the TV is plugged back in, the degaussing cir-
cuit will operate once to clear them up. Repeat this
procedure any time the TV screen is accidentally
magnetized, or when the TV is moved or relocated.
TV/VCR
WATCHING A TV PROGRAM
1 Turn on the TV/VCR/DVD
Press the POWER button to turn on the TV/VCR/DVD.
2 Select the channel number
Press the CHANNEL button K or L to select your
desired channel number or press the number on the
remote control.
Note for using the Number button on the remote
control:
¡You must precede single-digit channel numbers
with a zero (For example: 02, 03, 04 and so on).
¡When selecting cable channels which are higher
than 99, press +100 first, then press the last two
digits. (Example: to select channel 125, first press
“+100” then press “2” and “5”).
Remember: If the TV/VCR/DVD is connected to a
cable box or satellite box, the TV/VCR/DVD must
be on CH3 or CH4, then the channel to be viewed
must be selected on the cable box or satellite box.
3 Adjust sound
Press the VOLUME button
XX
or
YY
to adjust the volume.
NOTES:
•
If you press the CHANNEL button K or L in the
DVD mode, you can change the TV channels.
Even if you turn off the TV/VCR/DVD in the
DVD mode, when you turn it on again, it will go
into the TV/VCR mode.
TV/VCR
PICTURE CONTROL
The TV/VCR/DVD’s picture controls – BRIGHT,
CONTRAST, COLOR, TINT and SHARPNESS –
are preset to factory specifications. Although they are
usually the best, you may need to make some further
adjustments to your preference.
NOTES:
•
Procedures must be followed within 5 seconds or
the Picture Control mode will be cancelled.
•
When setting the Picture Control, the Game mode
will be cancelled.
Make sure ...
•
TV/VCR/DVD power must be turned on.
1 Select “PICTURE CONTROL”
Press the PICTURE button on the remote control.
2 Select item you want to adjust
Press the Arrow button K or L until desired control
is displayed.
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
3 Adjust the picture control
Press the Arrow button s or B to adjust to your
desired level.
TV/VCR
•
If there is a power failure of any kind, the
TV/VCR/DVD will retain its memory for this fea-
ture.
VOLUME 20
C C C C C C C C C C C C
BRIGHT
–
PPPPPPPPPPPPPPCCPPPPPPPPPPPPPP
+
to decrease
brightness
to decrease
contrast
to pale to brilliant
to green
to clear
to purple
to soft
to increase
brightness
to increase
contrast
BRIGHT
CONTRAST
COLOR
TINT
SHAPNESS
Arrow Button { Arrow Button B
T1055UF_EN(p1-35).QX3 04.6.3 2:43 PM Page 19