Filter
Top Products
OPERATION
Tuning in (continued)
Use the SEARCH function if desired channels can not be preset with the ASM or if you would like
to preset channels to specific position numbers one by one.
It is convenient to set the channel numbers to the same position numbers using SEARCH and SKIP
functions.
SEARCH
If ASM can not preset the desired channels, or you want to preset the desired channels one by one with
the preferred channel numbers, please make use of SEARCH.
Enter into PRESET menu, press the POS+/- button to
select and highlight POS. Press the VOL+/- button to
select a desired position number (from 0-255).
Note: you can also press 0-9 button to select a one-digit
position number.
Press --/--- button and number buttons to select a two-
digit or three-digit position number.
Press the POS+/- button to select SEARCH. Press the
VOL+ button to search channels from current channel
to higher channel. Press the VOL- button to search
channels from current channel to lower channel. When
a channel is located, the searching stops, this channel is
then memorized with the preset position number.
.
Note: you can also make use of BAND selection to quicken the
searching process in your desired band. Press the POS+/- button to
select BAND, pressing the VOL+/- button moves the band to the next
one in the sequence below.
V-L V-H UHF
PRESET
4
SKIP ON
BAND V-L
FINE
AFT OFF
SEARCH
ASM
S-RCV OFF
POS
3. When you want to store another channel at another position, repeat steps 1 & 2 above.
Note: After SEARCH, to exit the PRESET menu, press the RECALL button, or press PRESET
button or MENU button repeatedly until OSD disappears.
To preset channels (SEARCH)
PRESET
20
SKIP OFF
BAND V-H
FINE
AFT OFF
SEARCH
ASM
S-RCV OFF
POS
PRESET
4
SKIP ON
BAND V-L
FINE
AFT OFF
SEARCH
ASM
S-RCV OFF
POS
8
2.
1.