Filter
Top Products
Troubleshooting
37
Take steps described in the tables below to solve simple problems before contacting customer
service.
If you suspect something wrong with this unit, immediately turn the power off and disconnect the
power connector from the unit. Never try to repair the unit yourself because it is dangerous to do
so.
SYMPTOM
CHECK ITEM
There is no display on the
screen.
There is no sound.
There is no picture or picture
moves up and down.
The unit can't play discs.
The unit does not continue to
play discs or plays the same
section repeatedly.
The remote control does not
work.
Make sure the unit is turned on and all connections
correct.
Make sure the unit is turned on and all connections are
correct.
Make sure the volume is not turned down or muted.
Make sure the sound setup is correct.
In DVD mode, make sure disc is not dirty or warped.
Make sure all connections are correct.
Make sure the unit is in correct video mode.
Make sure disc is loaded in correctly.
Make sure disc is not dirty or warped.
Make sure the region code is the same as region code of DVD
disc.
Make sure water condensation has not occurred. If it occurs,
take out the disc and leave the unit on for at least one hour.
Make sure disc is not dirty or damaged.
Make sure the unit is not any repeat status.
.
Make sure there are no obstructions between remote control
and the unit.
Make sure the remote control is pointing at the unit.
Make sure the battery is installed into the remote control
correctly.
Make sure battery is not too weak.
Other Notes:
Static or other external interference may cause the unit to behave abnormally. In this occurrence,
unplug the power-supply cord from the outlet and plug it in again to reset the unit. If the problem
persists, then please disconnect the power and consult a qualified technician.