Filter
Top Products
13
HL57 (E/F) Web 213:276
Chapter 2: Connecting your TV
Connecting a DVD player with ColorStream
®
(component video), a VCR,
and a satellite receiver
Your TV has two sets of ColorStream
®
(component video) inputs.
IN from ANT
VIDEO AUDIO
OUT to TV
LR
R
L
OUT
IN
CH 3
CH 4
VIDEO
OUT
COMPONENT VIDEO
P
B
P
R
Y
AUDIO
OUT
L
R
S-VIDEO
OUT
S-VIDEO
OUT
VIDEO
OUT
AUDIO
OUT
COMPONENT VIDEO
L
R
Satellite
IN
P
B
P
R
Y
Stereo VCR
From antenn
a
TV upper back panel
TV lower back panel
TV right side panel
From satellite dish
Satellite receiver with component video
DVD player with component video
You will need:
• coaxial cables
• standard A/V cables
– For better picture performance, if your VCR has S-video,
connect an S-video cable and standard (analog) audio
cables to the VIDEO-2 inputs on the side panel (instead of
the VIDEO-1 inputs). Do not connect both types of video
cable to VIDEO-2 at the same time or the picture
performance will be unacceptable.
– If you have a mono VCR, connect L/MONO on the TV to
your VCR’s audio out terminal using the white audio cable
only.
•
standard audio cables
• component video cables
– You can connect the component video cables (plus audio
cables) from the DVD player or satellite receiver to either
set of ColorStream terminals on the TV (HD-1 or HD-2).
The ColorStream HD-1 and HD-2 terminals can be used
with Progressive (480p, 720p) and Interlaced (480i, 1080i)
scan systems. A 1080i signal will provide the best picture
performance.
– If your DVD player or satellite receiver does not have
component video, connect a standard A/V cable to
VIDEO-1. If your DVD player has HDMI video, see
page 15.
To view antenna or Cable channels:
Select the ANT video input source on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD2
video input source on the TV.*
To view satellite programs using the component video
connections:
Turn on the satellite receiver. Select the ColorStream HD1
video input source on the TV.*
To view the VCR or view and record antenna
channels:
Turn ON the VCR. Tune the VCR to the channel you want to
watch. Select the Video2 video input source on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to record.
Select the ColorStream HD2 video input source on the TV*
to view the DVD.
* To select the video input source, press INPUT on the remote control
(- page 30). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Laws of the United States and
other countries, and may subject you to civil and criminal
liability.
26323742HL57_EN.book Page 13 Wednesday, March 14, 2007 4:28 PM