Panasonic 32HL57 Flat Panel Television User Manual


 
26
HL57 (E/F) Web 213:276
Chapter 5: Setting up your TV
Selecting the menu language
You can choose from three different languages (English,
French and Spanish) for the on-screen display of menus and
messages.
To select the menu language:
1 Press Y and open the Set Up menu.
2 Press B or b to highlight Language.
3 Press C or c to display your desired language.
4 Press O to close the Set Up menu.
Programming channels into the
TV’s channel memory
When you press < or , on the remote control or TV control
panel, your TV will stop only on the channels you program into
the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
Note:
If the input signal type is set to CABLE for an antenna input,
the automatic channel programming process erases
channels that were previously programmed into the TV’s
memory.
If the input signal type is set to TV, the automatic channel
programming process does NOT erase channels that were
previously programmed into the TV’s memory, but adds
newly found channels to the existing set of programmed
channels. To remove a channel from the memory, you must
manually delete it.
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
Programming channels for an antenna input configured for
CABLE will take substantially longer than for an antenna
input configured for TV. This is normal; however, once
channel programming is completed, you should not have to
repeat the programming process again unless your Cable
TV service lineup changes significantly.
To program channels automatically:
1 Press Y and open the Set Up menu.
2 Press B or b to highlight TV/CABLE.
3 Press C or c to select either TV (if you use an antenna) or
CABLE (if you use cable channels).
Channel Labeling
Add/Erase
CH Program
TV/CABLE
Language
Set Up
MENU
Back Exit
EXIT
English
TV
Add
Video Label
ENTER
ENTER
1/2
Channel Labeling
Add/Erase
CH Program
TV/CABLE
Language
Set Up
MENU
Back Exit
EXIT
English
CABLE
Add
Video Label
ENTER
ENTER
1/2
26323742HL57_EN.book Page 26 Wednesday, March 14, 2007 4:28 PM