Filter
Top Products
18
Setting Addresses (CZ-RWSY1U/CZ-RWSK1U)
(Setting the address of the indoor unit)
1. First of all, set the address for the remote controller with Setting Remote Control
Address (See Page 16).
2. Press [Emergency Operation]
of the indoor unit for four seconds or more.
When you do this, the lamps of the display will blink one after another.
3. Press on the remote controller.
4. The buzzer will sound and the address of the indoor unit will change to the address
displayed on the remote controller.
5. If you press [Emergency Operation]
of the indoor unit once, the lamps on the indoor
unit’s display will turn off.
Note
• Please do not hold the [Emergency Operation]
button of the indoor unit down while the indoor unit’s
display lamps are blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to
“ALL” at the time of the shipment.
11. ADDRESSES (Cont.)