Filter
Top Products
7
3. INSTALLING BATTERIES
1. Remove the cover.
2. Insert two AAA alkaline batteries.
Put the batteries in with the polarity [+/–] as shown in the
fi gure.
3. Gently insert one end of an unfolded paper clip
(or a similar object that can fi t) into the Reset hole
and press the reset button inside the hole and
then put the cover back on.
Note
• Change the batteries when the display of the remote controller
gets weak or if it will not work unless close to the receiver.
(Alkaline batteries generally last about one year.)
• When changing batteries, always use two fresh batteries of the
same make.
• If the remote controller will not be used for a long period of
time, remove the batteries.
• Please dispose of batteries appropriately.
• After changing the batteries, follow the procedures on the next
page to reset the current time.
HOW TO REMOVE BATTERIES
1. Remove the cover.
2. Press the battery toward the negative end and
lift it out by its positive end. (As shown at right)
3. Remove the other battery in the same way.
Note
• Dispose of the used batteries at the designated location in
compliance with the applicable local ordinances.
Warning
• Do not swallow the battery.
• After removing the battery from remote controller, keep it away from the reach of children.
The battery can cause death by suffocation if swallowed.
• When inserting the battery, make sure the polarities (+ and -) are correct.
Reset hole
Cover