Filter
Top Products
Reference
29
VQT3B11
The images from this unit do not appear on
the television.
Picture is distorted.
¾
An incorrect resolution is selected in “HDMI Video
Format”. Reset the setting as follows:
1 While the unit is on, press and hold [OK], the yellow
button and the blue button on the remote control at the
same time for more than 5 seconds.
– “00 rEt” is displayed on the unit’s display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the unit until “04 PrG” is displayed on the unit’s
display.
3 Press and hold [OK] on the remote control or [< OPEN/
CLOSE] on the unit for at least 4 seconds.
Set the item again. ( 26)
– When Dolby Digital Plus, Dolby TrueHD, and DTS-HD
audio are not output in bitstream, select “Yes” in “Default
Settings” and make proper settings. ( 27)
¾
The unit and television are using different video
systems. Switch the setting as follows:
1 While the unit is on, press and hold [OK], the yellow
button and the blue button on the remote control at the
same time for more than 5 seconds.
– “00 rEt” is displayed on the unit’s display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the unit until “05 P/n” is displayed on the unit’s
display.
3 Press and hold [OK] on the remote control or [< OPEN/
CLOSE] on the unit for at least 4 seconds.
The system switches from PAL to
NTSC
or vice versa.
¾
The system used on the disc doesn’t match your television.
– PAL discs cannot be correctly viewed on an NTSC
television.
– This unit can convert NTSC signals to PAL60 for
viewing on a PAL television (“NTSC Contents Output”
in the “Picture”).
Video is not output in high-definition.
¾
Confirm that “HDMI Video Format” in the Setup menu
are set properly. ( 26)
A black band is displayed around the edge
of the screen.
The aspect ratio of the screen is abnormal.
¾
Confirm the “TV Aspect” is set properly. ( 26)
¾
Adjust the aspect setting on the television.
Cannot hear the desired audio type.
¾
Check the connections and the “Digital Audio Output”
settings.( 9 , 25)
¾
To output audio from a device connected with an HDMI
cable, set “HDMI Audio Output” to “On” in the Setup
menu. ( 26)
Disc cannot be played.
¾
The disc is dirty. ( 4)
¾
Check the region code. ( 7)
Still pictures (JPEG) do not playback
normally.
¾
The images that were edited on the PC, such as
Progressive JPEG, etc., may not playback.
I can’t playback BD-Live.
¾
Confirm that this unit is connected to the broadband
Internet. ( 9)
¾
Confirm the “BD-Live Internet Access” settings. ( 24)
¾
Confirm a USB device is inserted into the USB port.
( 13)
I can’t connect to the network.
¾
Confirm the network connection and settings.
( 9, 11, 26)
¾
Check the operating instructions for each device and
connect accordingly.
Picture
Audio
Playback
Network
DMP-BD75GNGCGAGW-VQT3B11.book 29 ページ ２０１１年２月９日 水曜日 午後７時２８分