Filter
Top Products
28
SQT0108
The TV screen turns black.
¾ When “24p Output” is set to “On”, HDMI
authentication takes place and a black screen
is displayed.
This unit does not recognize the USB
connection correctly.
¾ Disconnect and re-connect the USB cable. If
it still does not recognize the connection, turn
this unit off and on again.
¾ USB devices may not be recognized by this
unit when connected using the following :
– a USB hub
– a USB extension cable other than the
supplied with the Wireless LAN Adaptor
DY-WL5 (optional)
¾ If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
The images from this unit do not appear on
the TV.
Picture is distorted.
¾ An incorrect resolution is selected in “HDMI
Resolution”. Reset the setting as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– POWER LED starts to flash.
3 Press [8] and the blue button on the remote
control at the same time for more than
5 seconds.
Set the item again. (> 22)
– When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD
®
audio are not output properly,
select “Yes” in “Restore Default Settings”
(> 26) and make proper settings.
Video is not output in high-definition.
¾ Confirm that “HDMI Resolution” in the Setup
menu is set properly. (> 22)
No subtitles.
¾ When progressive output is on, closed
captions/subtitles cannot be displayed.
The subtitles overlap closed captions
recorded on discs.
¾ Turn off the subtitles or the closed captions.
(> 20, 23)
Closed captions are not displayed.
¾ Confirm that the source content supports CC.
¾ Confirm the “Closed Caption Display” is set to
“On”. (> 21, 23)
¾ Change the “Closed Caption Type” setting.
(> 21, 23)
¾ Confirm the “Analog CC” or “Digital CC” is set
properly (> 21, 23).
A black band is displayed around the edge of
the screen.
The aspect ratio of the screen is abnormal.
¾ Confirm the “TV Aspect” is set properly.
(> 25)
¾ Adjust the aspect setting on the TV.
Cannot hear the desired audio type.
¾ Check the connections and the “Digital Audio
Output” settings. (> 9, 23)
Disc cannot be played.
¾ The disc is dirty. (> 5)
¾ The disc is not finalized. (> 7)
¾ Confirm the “Mixed Data Disc Option” is set
properly. (> 25)
Still pictures (JPEG) do not play back
normally.
¾ The images that were edited on the PC, such
as Progressive JPEG, etc., may not be played
back.
I can’t play back BD-Live.
¾ Confirm that this unit is connected to the
broadband Internet. (> 10)
¾ Connect this unit to the network by a wired
connection.
¾ Confirm the “BD-Live Internet Access”
settings. (> 24)
¾ Confirm a USB device is connected to the
USB port. (> 13)
Picture
Audio
Playback
DMP-BD91_81_SQT0108_eng.book 28 ページ ２０１３年１２月３日 火曜日 午前１０時５０分