Filter
Top Products
En
24
<J2M10501B> 24
About condensation
If the player is moved suddenly from a cold place into
a warm room (in winter, for example) or if the tempera-
ture in the room in which the player is installed rises
suddenly due to a heater, etc., water droplets (conden-
sation) may form inside (on operating parts and the
lens). When condensation is present, the player will not
operate properly and playback is not possible. Let the
player stand at room temperature for 1 or 2 hours with
the power turned on (the time depends on the extent
of condensation). The water droplets will dissipate and
playback will become possible. Condensation can also
occur in the summer if the player is exposed to the
direct wind from an air-conditioner. If this happens,
move the player to a different place.
Cleaning the product
Unplug the power cord from the power outlet when
cleaning the player.
Clean the player using a soft cloth. For tough dirt,
apply some neutral detergent diluted in 5 to 6 parts
water to a soft cloth, wring out thoroughly, wipe off
the dirt, then wipe again with a soft, dry cloth.
Alcohol, thinner, benzene, insecticides, etc., could
cause the print or paint to peel off. Also, leaving rub-
ber or vinyl products in contact with the player for
long periods of time could mar the cabinet.
When using chemical-impregnated wipes, etc., read
the cautions included with the wipes carefully.
Caution for when the unit is
installed in a rack with a glass
door
Do not press OPEN/CLOSE on the remote control to
open the disc tray while the glass door is closed. The
door will hamper the movement of the disc tray, and the
unit could be damaged.
Cleaning the lens
The player’s lens should not become dirty in normal
use, but if for some reason it should malfunction due
to dust or dirt, consult your nearest Pioneer authorized
service center. Although lens cleaners for players are
commercially available, we advise against using them
since some may damage the lens.
About copyrights
This product incorporates copyright protection technol-
ogy that is protected by method claims of certain U.S.
patents and other intellectual property rights owned by
Macrovision Corporation and other rights owners. Use
of this copyright protection technology must be autho-
rized by Macrovision Corporation, and is intended for
home and other limited viewing uses only unless oth-
erwise authorized by Macrovision Corporation. Reverse
engineering or disassembly is prohibited.