Filter
Top Products
ENGLISH-25
Basic Operation
Turning off the power
Power indicator
Power indicator
Power indicator status
Red
Illuminated
The projector is in standby mode and image projection
is possible by pressing the POWER button.
A picture is being projected.
The lamp is cooling down after the power is turned
off. (The cooling fan is operating.)
The projector is preparing for projection after the
power is turned on while the power indicator is
illuminated orange. (After a short period, a picture
will be projected.)
The projector is preparing for projection after the
power is turned on while the power indicator is
illuminated red. (After a short period, a picture will be
projected.)
Flashing
Illuminated
Illuminated
Flashing
Green
Orange
Projector status
Press the POWER button.
B“POWER OFF” is displayed on the
screen.
Press the
II
or
HH
button to select “OK”, and
then press the ENTER button.
BThe lamp unit will switch off and the picture will stop being projected.
(The power indicator on the projector will illuminate orange while the
cooling fan is still operating.)
NOTE:
BYou can also turn off the power by pressing the POWER button twice or
by holding it down for at least 0.5 seconds.
BWhen the projector is in standby mode (the power indicator on the
projector is illuminated red), the projector continues to draw approximately
5 W of power even when the cooling fan has stopped.
#
$
%
POWER OFF
OK CANCEL
FREEZE
SHUTTER
INDEX
WINDOW
PROJECTOR
VOLUME D.ZOOM
STD
VIDEO
INPUT
POWER
RGB
MENU
AUTO
SETUP
ENTER
#
$
%
Power
cord
Direct power off function
You can disconnect the power cord during projection or immediately after
use and move the projector. The cooling fan will operate by the internal
power supply to cool down the lamp.
BWhen this function is used, it may take more time for the lamp to turn back
on again compared to when the lamp cools down with the power cord
connected.
BDo not put the projector in a bag while the cooling fan is operating.
Disconnect the power cord after the power
indicator on the projector illuminates red.
24-ENGLISH
CAUTION
If not using the projector for an extended period of time, disconnect the
power cord plug from the wall outlet.
BIf dust builds up on the power cord plug, the resulting humidity may
damage the insulation, which could result in fire.
BThis projector continues to draw approximately 5 W of power even when
the power is turned off.