Filter
Top Products
ENGLISH-37
Adjustments and settings
36-ENGLISH
BRIGHT
This adjusts the darker areas (black
areas) in the picture.
Black areas are too light: I button
Dark areas are too solid: H button
COLOR
(S-VIDEO/VIDEO/YPBPR only)
The color is too deep: I button
The color is too pale: H button
TINT
(NTSC/NTSC 4.43/YPBPR only)
This adjusts the flesh tones in the picture.
The flesh tones are greenish
: I
button
The flesh tones are reddish
: H
button
SHARPNESS
To soften the picture details
: I
button
To sharpen the picture details
: H
button
COLOR TEMP.
This is used to adjust the white
areas of the picture if they appear
bluish or reddish.
White balance R/G/B
(W-BAL R/G/B)
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised.
To make the selected color lighter
: I button
To make the selected color stronger
: H button
This should normally be set to
“AUTO”. If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
TV-SYSTEM AUTO
[
NTSC
[
NTSC4.43
[
PAL
[
PAL-M
[
PAL-N
[
SECAM
TV-SYSTEM
(S-VIDEO/VIDEO only)
AI
ON
The lamp is controlled according to
the input signals to project images
with the best quality.
OFF
“AI” is disabled.
COLOR TEMP. STANDARD
[
HIGH
[
LOW
STILL MODE
To reduce flickering of still images (vertical
flicker), set “STILL MODE” to “ON”.
SIGNAL MODE
(RGB/YPBPR only)
This displays the type of signal which is
currently being projected.
Refer to the table on page 58 for details on
each type of signal.
sRGB is an international color reproduction
standard (IEC61966-2-1) established by the
International Electrotechnical Commission
(IEC). If you would like the colors in sRGB-
compatible pictures to be reproduced more
faithfully, make the following settings.
##
Press the
FF
or
GG
button to select
“PICTURE MODE”, and then press the
II
or
HH
button to select “NATURAL”.
$$
Press the STD (standard) button on the
remote control unit.
%%
Press the
FF
or
GG
button to select
“COLOR TEMP.”, and then press the
II
or
HH
button to select “STANDARD”.
STILL MODE OFF
[
ON
AI ON
[
OFF
NOTE:
BsRGB is only enabled when RGB
signals are being input (when “LAMP
POWER” is set to “HIGH”).
NOTE:
BDo not set “STILL MODE” to “ON”
when playing back moving images.
NOTE:
B“AI” is disabled when “LAMP
POWER” is set to “LOW”.
(Refer to page 43.)
Projecting sRGB-compatible
pictures
NOTE:
BWhen set to “AUTO”, the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.