Filter
Top Products
55
*Important: If a remote control button does not work when pressed,
press the DVD button on the remote and try the button again.
AUDIO OUTPUT
SELECT :
SET : SET
END : ACTION
LPCM(DVD) : OFF
Dolby Digital : Bitstream
dts : Bitstream
DRC : OFF
SPEAKER SETUP
SPEAKER SETUP
Speaker Size Setup
1
Speaker frequency properties and the existence of speakers is set.
Press
to select “SPEAKER SIZE,” and press
SET
to display SPEAKER SIZE screen.
Press
to select an item, and press
SET
repeatedly. (See below table.)
3
2
DVD
Operation
SET
ACTION
SELECT
SPEAKER SETUP
SELECT :
SET : SET
END : ACTION
SPEAKER OUTPUT : MULTI-CHANNEL
SPEAKER OUTPUT : MULTI-CHANNEL
SPEAKER SIZE
OUTPUT BALANCE
DELAY TIME
Menu item
FRONT
CENTER
SURROUND
SUBWOOFER
Remark
Setting
LARGE(factory preset)
SMALL
LARGE(factory preset)
SMALL
NONE
LARGE(factory preset)
SMALL
NONE
ON(factory preset)
OFF
When the front speakers (R/L) supports low-frequency (under 100 Hz) reproduction.
Select when the front speakers (R/L) does not support low-frequency reproduction.
When the surround speakers (R/L) supports low-frequency (under 100 Hz) reproduction.
Select when the surround speakers (R/L) does not support low-frequency reproduction.
When the center speaker supports low-frequency (under 100 Hz) reproduction.
Select when the center speaker does not support low-frequency reproduction.
If there is no center speaker.
If there is no surround speaker.
If there is no subwoofer speaker.
If there is a subwoofer.
SPEAKER SIZE
SELECT :
SET : SET
END : ACTION
FRONT
FRONT
: LARGE
: LARGE
CENTER : LARGE
SURROUND : LARGE
SUBWOOFER :
O
N
Press
ACTION
four times to exit.
Speaker Output Setup
1
Press
to select “SPEAKER
SETUP,” and
press
SET
to display
SPEAKER SETUP
screen.
2
Set the number of speakers connected to the receiver
(amplifier, decoder.) (See pp. 14, 15.)
Do steps 1~3 on page 54.
Press
to select “SPEAKER
OUTPUT,”
and
press
SET
repeatedly.
(See below.)
■■
■■
■ SPEAKER OUTPUT
MULTI-CHANNEL: (Factory preset)
Use this setting when 3 or more speakers are
connected. In this case, it is necessary to set
[SPEAKER SIZE], [OUTPUT BALANCE], and
[DELAY TIME].
2-CHANNEL:
When 2 speakers are connected, it is not
necessary to set [SPEAKER SIZE], [OUTPUT
BALANCE], and [DELAY TIME] (these setting
menu are not displayed.)
4
Press
ACTION
three times to exit.
3
**If SUBWOOFER is set to “OFF,”
the front speakers are set to
“LARGE” automatically.
Do steps 1~2 of “Speaker Output Setup” above.
2 D4763S P36-60 (030512 –§”Ô•Ï•X2nd).p65 2003/05/14, 13:4755