Panasonic WJ-RT416 DVR User Manual


 
34
Recorder operation
The following operations of the recorder are available using this software.
Configuration of the settings of the recorder
Check of each log of the recorder
Check of the system information and disk information of the recorder
Start/stop of the manual recording using this software
Determination whether to enable or disable the alarm output from the AUDIO IN/ALARM OUT terminal on the
rear of the recorder
Reboot of the recorder
Download/upload of the setup data from/to the recorder
Download/upload of the language data from/to the recorder
Firmware update of the recorder
To operate the recorder, log in the recorder first. ( page 18)
When clicking the [Recorder Config.] button, the pop-up menu will be displayed.
Configuration of the settings of the recorder
System Setup (Setup – System Setup)
Configure the basic settings relating the system of the recorder.
Screenshot 1
Select "System Setup" under "Setup" from the pop-up
menu.
The "System Setup" window will be displayed.
Step 1
The setup items on the "System Setup" window are the
same as the items on the setup menu ("System Setup",
"Display Setup", "User Level Setup", "Manager
Password", "Operator Password" and "Viewer
Password") of the recorder.
Refer to the installation guide of the recorder for further
information about the setup items.
Notes:
The camera title (up to 10 characters) can be set on
the "Display Setup" tab.
The camera title should be named in the language
selected for "Language" on the "System Setup" tab.
Step 2
When completing the settings, click the [Apply] button.