Filter
Top Products
24
END : TIMER REC
CH
––
DATE ON OFF
SP
13:45 14:1517TU
G-CODE
END : TIMER REC
CH
23
DATE ON OFF
SP
13:45 14:1517TU
G-CODE
SP ON SP OFF
3 Press the ENTER button U.
¡ The entered programme
appears on the display.
¡ The starting time and the
ending time appears
alternately each 5 seconds
on the VCR display.
¡ Confirm that the number
corresponds to the right
programme. If the display looks
like this and Á on the VCR
display
flashes on and off: select
the desired programme position
using the CH button :, then
press the ENTER button U.
¡ To make any corrections, use the DATE button ;, the
ON button G, the OFF button F and the SPEED
button E the same way as described on page 21.
4 Press the TIMER REC button D to switch the VCR
over to the timer recording standby mode.
≥ Check that “Á” is lit on the VCR display.
If it is flashing, check the timer recording details again.
(See page 23.)
Notes:
¡ When the G-Code number is used for programming, the
recording time may be slightly longer than the actual
programme time.
¡ Repeat steps 2 and 3 if “PROGRAMME IS INCOMPLETE.”
appears.
¡ When programming two or more programmes, repeat
steps 1–4.
¡ The procedures for checking and cancelling a timer
programme are the same as on page 23.
G-Code Programming
Programming is now easier than ever; simply enter the
G-Code number found in the programme scheduling pages
of newspapers and magazines.
G-Code numbers are numbers assigned to programmes
listed in the TV programme schedule found in newspapers
and TV guides. When these numbers are entered, the
numbers are converted to actual programming.
Preparations
≥ Confirm that the VCR is on.
≥ Confirm that the TV is on and the VCR viewing channel is
selected.
≥ Insert a video cassette with an intact erasure prevention
tab.
≥ Set the VCR/TV switch R to “VCR”.
¡ Check that the clock is set to the correct time. If it has not
been set, refer to page 12.
Example:
Programming a timer recording of a TV programme with the
G-Code number 123456
Operations
1 Press the G-CODE button M
to display the menu for
entering the G-Code number
on the TV.
2 Press the Numeric buttons 2
to enter the G-Code number.
≥ It is also possible to check the
number with VCR display
without appearing the On
Screen Display.
≥ If you have entered a wrong number, press the
CANCEL button A then enter the proper number. An
alternative method is to press the Cursor button (2)
T and then enter the proper number
END:G-CODE
---------
G-CODE
SET:ENTER
END:G-CODE
PROGRAMME
123456
---
G-CODE
To Suspend the Timer Recording Standby
Mode
See the page 21.
On Screen Display
VCR display