Filter
Top Products
33
Basic Operation
CH
CH
VOL VOL
OK
Channel and Program tuning in digital television differs
from conventional television. With DTV, many programs
can exist within a single 6 MHz channel. These channels
behave as sub-channels within a single channel. When
tuning to a digital channel, the unit will also tune to a
program and will indicate the channel and program in the
on-screen Channel Banner display.
In order to select channels properly, Auto program must
be performed (P. 29).
Follow the procedure below to directly enter the channel
number using the NUMBER keys on the Remote
Control.
1
Press the
NUMBER keys on the
Remote Control to enter the Channel
number. Press OK.
The following is an example of tuning
to channel 15.
If tuning a digital channel and your
channel contains more than one
program, press PROG and enter
the program (1, 2, 3 etc.) using the
NUMBER keys. Press OK. The
following is an example of tuning to
channel 15-1.
Direct Tuning Example
Step Action
Channel Banner
Display
1 Press 1 1
2 Press 5 15
3 Press - 15-
4 Press 1 15-1
5 Press OK 15-1
123
4
5
6
78
0
9
PROG
123
4
5
6
78
0
9
Select analog channel
Select digital channel
2
4
123
4
5
6
78
0
9
3
Direct Tuning Example
Channel and Program Tuning
Step Action
Channel Banner
Display
1 Press 1 1
2 Press 5 15
3 Press OK 15
Unit Status display
Channel Banner: Minimized
Press CH
<
>
to minimize the displayed
channel banner. It will display the
channel number, and the station
identification (if available).
Channel Banner: Maximized
Press RECALL to maximize the
displayed channel banner.
15-2
ABC - HD
Channel Number
Station identifier
Closed Caption
Channel, Program and Station identifier
Press the Channel
<
>
or RECALL button, except when
the MENU screen is dis played, to display current unit
status information.
CH
CH
VOL VOL
OK
15-2
ABC - HD
Andrew’s cooking show
1080i
TV-G
STANDARD
4 : 3
30
CC SAP
Program title
SAP indication
Rating
Signal resolution
Picture mode
setting
Aspect
Time remaining
in Sleep Timer
Notes:
• The channel number and volume level are stored even after
the unit is turned off.
• Power consumption can be reduced if the volume level is
lowered.
Using the CH/ VOL Button
Select desired channel:
Press CH
<
>
or NUMBER keys.
Adjust to desired volume level:
Press VOL + or VOL -.
CH
CH
VOL VOL
OK
Note:
• If, during channel selection, no action is taken for several
seconds, the Channel Banner is exited and the currently input
channel is automatically selected.
1
2
Note:
• If, during channel selection, no action is taken for several
seconds, the Channel Banner is exited and the currently input
channel is automatically selected.
Note:
• The Station identifier is not displayed when you use Split
Screen mode.