Filter
Top Products
25
Basic Operation
For your convenience, First Time Set up menu will
be displayed on screen when the set is turned on
for the first time. If needed, follow the menus and
procedures displayed on-screen for setting up the
features.
Auto program
You can scan All (Analog and Digital) channels. If
needed, follow the menus and procedures displayed
on-screen for setting up the features. You can also make
the settings in Setup menu.
Notes:
• After “Auto program” is completed the unit tunes to the first
channel found during “Auto program”.
• If setup is incomplete, check connection of Antenna/Cable to
the RF IN Terminal, then try “Auto program” again. (p. 29)
• “Auto program” must be done when you select the input
signal for the first time or whenever you change the antenna
configuration.
• Depending on conditions, “Auto program” may take a while.
First Time Setup
Language
The language of the on-screen display is set to English
as the factory setting.
You can select English, Spanish or French as the
on-screen displays language.
Press to select “Language”.
Language ◄ English ►
Language
Press to display Language
screen.
1
Press to select “English,”
“Español” or “Français”.
2
3
Press to go to previous
screen. Or, select icon,
then press OK for same
results.
ANT In ◄ Cable ►
Mode All
Start scan
Auto program
Press to select “ANT In”.
Press to select “Cable” or
“Antenna”.
2
Press to select Mode.
Press to select “All” or
“Analog”.
3
ANT In Cable
Mode ◄ All ►
Start scan
Auto program
4
Press to select “Start scan”.
Press to start.
Channels available for
reception will be set
automatically.
ANT In Cable
Mode All
Start scan
Auto program
Now scanning analog channel...
Progress
5
After Auto program is complete, the unit will return
to Manual program mode. To place the channels
that were located by auto scan in memory, move the
cursor to “Apply” and press OK. (p. 30-31)
If OK is not pressed after selecting APPLY, the
channels will not be memorized.
Language
Auto program
First time setup
Press to select “Auto
program”.
Press to display Auto program
screen.
1
Language
Auto program
First time setup
Downloaded from www.Manualslib.com manuals search engine