Filter
Top Products
12
Name and function of parts
Lamp unit cover
The lamp unit is housed.
MAIN POWER switch (page 24)
Use this switch to turn on “I” and off “O” the main
power applied to the projector.
Remote control receiver window (rear) (page 14)
This also receives the signal beam coming from
the remote control.
POWER ON ( I ) button (page 24)
Turns on the power.
POWER STANDBY ( ) button (page 25)
Switches the power to the “standby” mode.
RGB1 button (page 24)
Switches to RGB1 input.
RGB2 button (page 24)
Switches to RGB2 input.
VIDEO button (page 24)
Switches to video input.
S-VIDEO button (page 24)
Switches to S-VIDEO input.
MENU button (page 29)
Displays and clears the MAIN MENU. It can also
return to the previous screen when the menu is
displayed.
The on-screen display (OSD) selection menu can
be displayed by holding down the menu key for at
least three seconds.
Air exhaust vents AUTO SETUP button (page 27)
Pressing this button while projecting an image
automatically corrects the picture positioning on
the screen.
DVI button (page 24)
Switches to DVI-D input.
SHUTTER button (page 27)
Press this button to black out the image
temporarily.
ENTER button (page 29)
Press this button to enter your menu selection or to
run function.
LENS button (page 26)
Switches to the adjustment mode for lens focus,
zoom and shift (position).
Arrow ( ) buttons (page 29)
Use to select an item on the menu screen, change
setting and adjust the level.
Also use them to enter the “SECURITY” password.
Rear view of the main unit Controls on rear panel
Controls on rear panel
Do not place your hands or other
objects close to the air outlet port.
• Heated air comes out of the air outlet port. Do not
place your hands or face, or objects which cannot
withstand heat close to this port [allow at least 50
cm (19.7") of space], otherwise burns or damage
could result.