Filter
Top Products
13
Simple Setup
AC mains lead connection / Preparing the remote control
13
RQTX0099
[PT865] AC mains lead connection for the wireless system:
∫ Batteries
≥Do not use rechargeable type batteries.
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ 17), avoiding obstacles,
at a maximum range of 7 m directly in front of the unit.
AC IN
AC mains lead
(included)
To household
mains socket
The wireless system consumes a small amount of power, even
when it is in “OFF” mode (approx. 0.3 W). To save power when the
unit is not to be used for a long time, unplug it from the household
AC mains socket.
An additional AC mains lead is included for use with the wireless
unit and not for use with other equipment. Also, do not use cords
for other equipment with the wireless system.
Ferrite core
step
6
Preparing the remote control
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
SC-PT560_860GN-RQTX0099-B_eng.book Page 13 Monday, January 28, 2008 10:23 AM