Filter
Top Products
- 24 -
Others
Set whether the high quality audio output from the optical terminal will be
output as is (“off”) or not (“on”).
≥ When this unit is connected to a device that does not support a
sampling frequency of 88.2 kHz or higher, change the setting to
“on”.
This unit will downsample the frequency as follows before
outputting audio.
(Audio will not be heard when “off” (default) is set.)
– 88.2 kHz / 176.4 kHz # 44.1 kHz
–96kHz / 192kHz# 48 kHz
Touch and hold [MODE].
≥ The mode indicator (amber) blinks.
– Blinks once: on
– Blinks twice: off (default)
And then, the network indicator is blinking in blue and red while the
setting is being changed.
Operations other than turning on/off this unit cannot be performed. Wait
until the blinking stops.
≥ For a sampling frequency of the connected device, refer to the operating
instruction for the connected device.
≥ If you set the downsampling setting to “on”, audio from the analog terminal will
also be downsampled.
Downsampling