Filter
Top Products
4 EN 5EN
2
Gettingstarted
2.1 Insertingthebatteries
• Insert 2 AAA type
batteries, noting the
+ and -
configuration in the
battery
compartment.
Note
When replacing the batteries, all user settings
will be retained in the remote control
memory for 5 minutes.
2.2 Settinguptheuniversalremote
control
The example below instructs you how to set up
your universal remote control for your TV.
You can repeat the same steps for other devices
(
DVD player/recorder and Cable/Satellite box
)
which you want to operate, using the SRP2003.
The remote control can be set up to operate
any 3 of the following devices:
Devicename Description
TV Traditional TV, at screen
TV and projection TV, TV
part of TV / VCR, TV / VCR
/ DVD and TV / DVD
combos
DVD DVD player / recorder
(DVDR), DVD / Hard
Disk Drive combination
(DVDR-HDD), Blu-Ray
player, High Denition
DVD player (HD-DVD),
DVD part of TV / DVD, TV
/ VCR / DVD and VCR /
DVD combos
CBL/SAT Cable box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Denition Television
decoder (HDTV) and Tivo
Example:settinguptheuniversalremote
controltooperateyourTV:
1 SwitchON the TV manually or use the
original remote control for this. Tune to
channel 1.
2 Press and hold the
device selection
button for 5 seconds
until the red Setup
light
remains lit .
The remote control
is now in setup mode.
3 Look up the 4-digit
code for your brand
in the
brand list
at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit
buttons to enter the
code for your brand.
• If the red Setup
light
turns off,
an invalid code
was entered. In this case, try again.
4 Aim the remote
control at the TV.
Press and hold the
button. Release
it immediately as
soon the TV
switches off.
• This step normally takes between
5 and 60 seconds. In extreme
circumstances this step can take up to
15 minutes.
Gettingstarted English
5sec.
5-60sec.
5-60 SEC
.