Filter
Top Products
12
English
Attaching Ferrite core
Be sure to attach the provided ferrite core to the Power
code to reduce interference or electrical noise.
∗
1.2 ” (30 mm)
Back of the TV
1 Attach the ferrite to Power cord on the TV side as
shown.
2 Close the ferrite core until it clicks.
personal injury may result. Contact your nearest
Panasonic Dealer immediately.
During set-up, make sure that all screws are
securely tightened.
●
If sufficient care is not taken to ensure screws are
properly tightened during assembly, the pedestal will
not be strong enough to support the TV, and it might
fall over and become damaged, and personal injury
may result.
When removing the pedestal, do not remove the
pedestal by any methods other than the specified
procedure. (p. 11)
●
Otherwise, the TV and/or pedestal may fall over and
become damaged, and personal injury may result.
■ Moving the TV
Before moving the TV, disconnect all cables.
●
Move the TV with at least two
people. Support as shown to
avoid injury by the TV tipping
or falling.
Warning
●
Do not place the TV on sloped, soft, cushioned or
unstable surfaces, and ensure that the TV does not
hang over the edge of the base.