Panasonic TC-P65ST30 Flat Panel Television User Manual


 
18
About wireless LAN
To use the Wireless LAN Adapter, an access point needs to be obtained.
For the additional information for Wireless LAN Adapters, check the following website:
http://Panasonic.com/NetConnect
It is recommended to use the Wireless LAN Adapter with the supplied extension cable.
Do not use the Wireless LAN Adapter to connect to any wireless network (SSID*) for which you do not have usage
rights. Such networks may be listed as a result of searches. However, using them may be regarded as illegal access.
* SSID is a name for identifying a particular wireless network for transmission.
Do not subject the Wireless LAN Adapter to high temperatures, direct sunlight or moisture.
Do not bend, or subject the Wireless LAN Adapter to strong impacts.
Do not disassemble or alter the Wireless LAN Adapter in any way.
Do not attempt to install the Wireless LAN Adapter in any incompatible device.
When VIERA Connect, Network camera, DLNA, or other device is using the network, do not disconnect the Wireless
LAN Adapter.
Check that the Access point supports WPS*.
(If it does not support WPS, the encryption key of the Access point is required when configuring settings.)
Follow the instructions on the Access point setup screen and configure the appropriate security settings.
For more details on setting of Access point, please refer to operating manual for the Access point.
We recommend using 11n (5 GHz) for the wireless system between the Wireless LAN Adapter and Access point.
Communication is also possible with 11a, 11b, and 11g (2.4 GHz), but the communication speed may be slower.
If the wireless system of the Access point is changed, devices that could connect by wireless LAN may no longer be
able to connect.
Data transmitted and received over radio waves may be intercepted and monitored.
Keep the TV away from the following devices as much as possible:
Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the TV failures such as
malfunction may occur due to the radio wave interference.
When noises occur due to the static electricity, etc., the TV might stop operating for the protection of the devices. In
this case, turn the TV Off with power On / Off switch, then turn it On again.
* WPS: Wi-Fi Protected Setup
Wireless network (First time setup) in
Display “Wireless network”
Select the connection method
select
OK
Wireless network
WPS (Wi-Fi Protected Setup using push button)
Please choose connection method:
Search for wireless networks
Follow the directions on screen to complete the setting.
See page 41 for more information.