Panasonic TH-42PS9XK Flat Panel Television User Manual


 
9
Connections
1
2
SERIALPC IN
AUDIO
SLOT1 SLOT2 SLOT3
VIDEO
P
R
/C
R
/R P
B
/C
B
/B
Y/G
AUDIO
RL
COMPONENT/RGB IN
AUDIO
RL
AUDIO
RL
AV INBA
S VIDEO
1
2
1
2
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable xing bands
Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
(Example: TH-42PS9UK)
Speakers (Optional accessories)
Pass the attached cable
xing band through the
clip as shown in the
gure.
To secure cables connected to Terminals, wrap the cable xing band around them then
pass the pointed end through the locking block, as shown in the gure.
While ensuring there is suf cient slack in cables to minimize stress (especially
in the power cord), rmly bind all cables with the supplied xing band.
From SERIAL
Terminal on Computer
(see page 11)
From EXTERNAL
monitor terminal on
Computer (see page 10)
AC cord connection (see page 13)
Dual Video
Terminals
(see page 12)
To tighten:
To loosen:
Pull
Pull
Push the catch
3. Slide up the clamper and x
the AC cord plug securely.
2. Insert the AC cord
and close the clamper
securely.
1. Open the clamper.
Clamper
AC cord
Note: The power plug in the illustration may not be the type tted to your set.
When loosen
the clamper:
Notes:
At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
TH-37PH9UK has two slots only.
– AC cord xing
4. Insert the point of the
xed clamper into the
small hole on the lower
right of
the back
cover as
necessary.
Optional Terminal
Board Insert Slot
(covered)
COMPONENT/RGB IN
and Audio IN Terminals
(see page 12)