Filter
Top Products
7
Accessories
Power supply cord Fixing bands × 2
Batteries for the Remote
Control Transmitter
(2 × R6 (UM3) Size)
Remote Control Transmitter
EUR7636070R
Operating Instruction book
Accessories Supply
Check that you have the accessories and items shown
Remote Control Batteries
Requires two R6 batteries.
1. Turn the transmitter face down.
Press and slide off the battery
cover.
2. Install the batteries as shown in the
battery compartment. (Polarity + or
– must match the markings in the
compartment.)
3. Replace the cover and slide in
reverse until the lock snaps.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5.
Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
“R6 (UM3)” size
+
+
-
-