Filter
Top Products
8
Connections
1
2
1
2
1
2
SERIALPC IN
AUDIO
SLOT2SLOT1 SLOT3
VIDEO IN
VIDEO OUT
AUDIO
IN
RL
AV
S VIDEO IN
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
(Example: TH-42PWD8WK)
AC cord connection
(see page 12)
Speakers (Optional accessories)
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
3. Slide up the clamper
and fi x the AC cord
plug securely.
2. Insert the AC cord
and close the clamper
securely.
1. Open the clamper.
Clamper
AC cord
Note: The power plug in the illustration may not be the type fi tted to your set.
– AC cord fi xing
Notes:
• At factory shipment, Terminal board is installed in SLOT 1 only.
• TH-37PWD8WK/S have two slots only.
4. Insert the point of the
fi xed clamper into the
small hole on the lower
right of
the back
cover as
necessary.
When loosen
the clamper:
AV Terminals
(see page 11)
Optional Terminal
Board Insert Slot
(covered)
From EXTERNAL
monitor terminal on
Computer (see page 9)
From SERIAL Terminal
on Computer
(see page 10)
Optional Terminal
Board Insert Slot
(covered)