Panasonic TH-50PZ850AZ Flat Panel Television User Manual


 
CH Display / Receive Programme CH Display / Receive Programme
CH 1
~
CH 11 CH 74
~
CH 78
CH 21
~
CH 70 CH 80
~
CH 120
Audio Signal STEREO
MAIN
I
SUB
II
MONO
Mode Indicator
I II
Type of broadcast
Regular broadcast
(Standard Audio)
Regular + NICAM MONO
I
(MAIN
I
)
NICAM STEREO
NICAM DUAL MONO
(MAIN
I
/ SUB
II
)
Mode Indicator
No Indicator
I
I
II
Type of broadcast
Regular broadcast
(Standard Audio)
BILINGUAL or DUAL MONO:
MAIN
I
/ SUB
II
STEREO
Mode Indicator
No Indicator
III
46
Technical Information
Programme Allocation (Analogue TV mode)
Rating (Digital TV mode)
Rating Meaning
- Not classi ed
G General Programmes
PGR Parental Guidance Recommended
AO Adults Only
Stereo / Bilingual Sound Selection (Analogue TV mode)
Note
If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switching
occurs, it is recommended you switch from STEREO to MONO.
Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position.
DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
When you receive the stereo / bilingual sound system, sound output modes can be selected by “MPX” in the
Sound Menu (p. 26).
NICAM .......Used in New Zealand, Singapore, Hong Kong etc.
A2(German) .......Used in Australia, Malaysia etc.
Note
During downloading, do not turn Off the TV or touch any buttons.
(The TV is automatically activated after downloading is completed.)
When the TV is switched to standby, there will be a clicking sound after a short delay. Similar clicking sounds will also
occur at 3:00 AM and 5:00 AM when “Auto update Search in Standby” (p. 32) is set to “On”. These sounds are normal.
Update system software to ensure that you have latest version software.
If there is an update available, a noti cation banner is displayed when the service has the update information.
To download new software, press “OK” Downloading (approx. 20 mins.)
If you choose not to download, press “EXIT”.
To update automatically
Set “Auto Update Search in Standby” to “On” (p. 32)
If there is a new version software being broadcast, the TV will download this automatically.
The automatic updating sequence is carried out at 3:00 AM and 5:00 AM every morning under the following condition.
Standby (TV turned Off with the remote control)
To update manually
Perform “System Update Search Now” (p. 32)
If there is an update available, a noti cation banner is displayed.
To download new software, press “OK” Downloading (approx. 20 mins.)
If you choose not to download, press “EXIT”.
Updating the software system (Digital TV mode)